Please read this entire document carefully before beginning your exam!
In this article, you will find information on:
- Introduction
- Section 1: Exam Requirements
- Section 2: Exam Information
- Section 3: Submission Instructions
- Additional Required Information
- Results
INTRODUCTION
This guide explains the objectives of the OffSec Exploit Developer (OSED) certification exam. Section 1 describes the requirements for the exam, Section 2 provides important information and suggestions, and Section 3 contains instructions for submitting your completed exam.
The OSED certification exam is comprised of three independent tasks related to exploit development that must be solved.
You have 47 hours and 45 minutes to complete the exam.
This means that if your exam begins at 09:00 GMT, your exam will end at 08:45 GMT two days later.
Once the exam is finished, you will have another 24 hours to send your documentation to the OffSec Challenges Department. Details on how to submit your files are provided below.
All OSED exams are proctored.
Please make sure to read the proctoring tool learner manual and the proctoring FAQ at the following URL: https://help.offsec.com/hc/en-us/sections/360008126631-Proctored-Exams
SECTION 1: EXAM REQUIREMENTS
Once a working exploit has been created, it must be used against a designated target machine and a shell must be obtained. From the shell, a proof.txt file located on the desktop of the administrator user must be retrieved.
Specific instructions for your tasks will be located in your Exam Control Panel, which will only become available to you once your exam begins.
Documentation Requirements
You are required to write a report describing your vulnerability discovery and exploitation process for each task you solve.
Your report must document all of the steps you perform. Your documentation should be thorough enough that your attacks can be replicated step-by-step by a technically competent reader.
The documentation requirements are very strict and failure to provide sufficient documentation will result in reduced or zero points being awarded. Please note that once your exam and lab report is submitted, your submission is final. If any screenshots or other information is missing, you will not be allowed to send them and we will not request them.
Exam Proofs
Tasks that require an exploit to be created will have an associated target machine where a copy of the vulnerable software is running.
You must use your developed exploit to compromise the target machine and retrieve the proof file.
Each target machine contains only one proof file. You must submit it in your control panel and include it in a screenshot with your documentation. Failure to provide the appropriate proof files in a screenshot will result in zero points being awarded for the task.
The only accepted way to provide the contents of the proof files is in a remote interactive shell on the target machine with the type command from their original location.
Obtaining the contents of the proof files in any other way will result in zero points for the target machine. This includes any type of web-based shell.
Control Panel Submission
The exam control panel contains a section to submit your proof files. The contents of the proof.txt files obtained from your exam machines must be submitted in the control panel before your exam has ended.
Screenshot Requirements
Each proof.txt must be shown in a screenshot that includes the contents of the file, as well as the IP address of the target by using ipconfig. An example of this is shown below:
Exam Restrictions
You cannot use commercial software such as Metasploit Pro, Cobalt Strike, Core Impact, or Burp Suite Pro. Also, AI chatbots such as ChatGPT, YouChat, and similar are not allowed. In addition, reverse engineering must be performed with IDA Freeware and WinDBG as taught in the course. Alternative disassemblers such as Ghidra are not allowed, nor is the commercial version of IDA Pro. Remote mounting of application binaries is also not allowed (e.g. using sshfs, sftp etc.)
All code to solve the three tasks must be written in Python3. Note that Metasploit Community is allowed for use in the exam.
NOTE: While you may use Discord as a resource for searching for information during the exam, under no circumstances are you permitted to seek or receive assistance from others on the platform.
These restrictions are both to facilitate a fair and balanced exam, and to enable proper grading.
Downloading any applications or source code from the exam environment to your local machine unless specifically allowed is strictly forbidden. For more information, please refer to the https://www.offsec.com/legal-docs/
SECTION 2: EXAM INFORMATION
Exam Connection
Your connection to the exam is to be done with Kali Linux using OpenVPN. We are unable to provide any VPN connectivity support if you choose to use another setup. Your exam connection pack and details will be sent by email at the exact start time of your exam and not in advance.
1) Download the exam-connection.tar.bz2 file from the link provided in the exam email to your Kali machine.
2) Extract the file:
kali@kali:~$ tar xvfj exam-connection.tar.bz2
OS-XXXXX-OSED.ovpn
3) Initiate a connection to the exam lab with OpenVPN:
kali@kali:~$ sudo openvpn OS-XXXXX-OSED.ovpn
4) Enter the username and password provided in the exam email to authenticate to the VPN:
kali@kali:~$ sudo openvpn OS-XXXXX-OSED.ovpn
OpenVPN 2.3.4 x86_64-pc-linux-gnu [SSL (OpenSSL)] [LZO] [EPOLL] [PKCS11] [MH] [IPv6] built on Dec 1 2014
Enter Auth Username: OS-XXXXX
Enter Auth Password: XXXXXXXXXX
Thu Mar 18 21:22:06 2016 WARNING: No server certificate verification method has been enabled. See http://openvpn.net/howto.html#mitm for more info.
Thu Mar 18 21:22:06 2016 LZO compression initialized
Thu Mar 18 21:22:06 2016 UDPv4 link local: [undef]
Thu Mar 18 21:22:06 2016 UDPv4 link remote: x.x.x.x:1194
Thu Mar 18 WARNING: this configuration may cache passwords in memory
Thu Mar 18 [127.0.0.1] Peer Connection Initiated with x.x.x.x:1194
Thu Mar 18 21:22:07 2016 TUN/TAP device tap0 opened
Thu Mar 18 /sbin/ifconfig tap0 192.168.xx.xx netmask 255.255.254.0 mtu 1500
Thu Mar 18 21:22:07 2016 Initialization Sequence Completed
Exam Control Panel
The exam control panel is available via a link provided in your exam email. Through the exam control panel you will be able to:
- Submit proof files
- Revert target machines
- View specific target objectives and point values
Machine Reverts
You have a limit of 50 reverts. This limit can be reset once during the exam. All of the machines will have been freshly reverted at the start of your exam, so you will not be required to revert the machines when you begin.
Please wait patiently for a machine to revert and only click the button once per attempt. Reverting a target machine will cause it to return to its original state, and any changes you have made to the machine will be lost.
Point Allocation
- The order in which the exam tasks are documented inside your exam report is the same order in which they will be graded and valued
- Points will only be awarded for full completion of a task
- Each task has a specific set of objectives that must be met in order to receive full points
- You must obtain a minimum score of 60 points out of a possible 100 points to pass the exam
Point Disqualification
You will receive no points for a specific assignment for the following:
- Using a restricted tool
- Failure to provide the proof.txt file contents in both the control panel and in a screenshot
Suggested Documentation Templates
Ideally, one of the following templates should be used for the penetration test report.
You may use your own template as long as the information is presented in a structured, professional manner and follows all other requirements outlined above.
Guidelines for Handling Unforeseen Factors during the Exam
This subsection of the exam guide documents what you should do in case you are unable to complete your exam due to severe external factors. Please make sure to read and understand it carefully.
The exam lab is a dedicated environment with no learners connected other than yourself. The total allotted time of 47 hours and 45 minutes does take life and its situations into consideration:
- You are expected to take rest breaks, eat, drink and sleep
- You are also expected to have a contingency plan in the event that there is an issue outside your control. (e.g. ensure you have access to a backup Internet connection, Kali Virtual Machine, power etc)
If you have a legitimate issue, please send an email with your OSID to "challenges AT offsec DOT com" immediately. Make sure to include all the necessary details and supporting information such as a letter from your power company, ISP or any other relevant documentation.
Please note we are only able to extend the lab time if the issues were present on our side and only when the exam subnet is not immediately in use by another learner following your exam. In the event of an issue on our side and the exam subnet is scheduled immediately following your exam we will provide a free exam retake attempt. We work very hard to ensure our environments are highly available and issues are very rare.
Contact Protocol
If you encounter any connectivity problems with the VPN or target machines, inform us immediately, directly in the proctoring chat. Should you not be able to access the proctoring tool, please contact us via the live chat available at https://chat.offsec.com/ or via email to "help AT offsec DOT com".
Please note that we will not be able to assist with or give hints on any exam objectives, and we will only be available to help resolve technical problems during the exam.
SECTION 3: SUBMISSION INSTRUCTIONS
Submission Checklist:
- Your exam report is in PDF format
- You have used the following format for the PDF file name "OSED-OS-XXXXX-Exam-Report.pdf", where "OS-XXXXX" is your OSID
- The code for each solved assignment is in separate Python3 files (.py)
- You have used the following format for the python file name for each assignment:
- "assignment1.py"
- "assignment2.py"
- "assignment3.py"
- Your PDF and Python files have been archived in a .7z file (Please do NOT archive it with a password)
- You have used the following format for the .7z file name "OSED-OS-XXXXX-Exam-Report.7z", where "OS-XXXXX" is your OSID
- You have made sure that your archive is not more than 200MB
- You have uploaded your .7z file to https://upload.offsec.com
Note that the filename is case sensitive. Learners must submit their exam file following the exact filename format structure above. If your file does not follow the exact filename format and structure, the application will not accept it.
The following subsections provide details on each of these requirements.
Submission Format and Name
You exam report must be submitted in PDF format archived into a .7z file along with the Python proof of concept files.
If you submit your report in any other file format, we will not request or remind you to send a PDF report archived into a .7z file and your exam report will not be scored.
Before submitting your exam report, please review the PDF document to ensure the format and content appear as it did in your original edition document and that there are no formatting errors.
After uploading your exam file to upload.offsec.com, the site will provide you with the MD5 hash of your uploaded file.
Please make sure to verify that you have uploaded your report correctly by checking and comparing the MD5 hashes of your uploaded exam file and the file you have locally.
If the values do not match, that means your file did not upload successfully. Click on "Select a new file" and upload your archive again.
root@kali:~# md5sum OSED-OS-XXXXX-Exam-Report.7z
f7feecea01ac1eca9ee522906b087d5e OSED-OS-XXXXX-Exam-Report.7z
Archive File
Please do not archive your .7z and PDF(s) files with a password. Our system will not accept should you upload a password-protected files.
You must submit your documentation in a .7z file.
root@kali:~# 7z a OSED-OS-XXXXX-Exam-Report.7z OSED-OS-XXXXX-Exam-Report.pdf assignment1.py assignment2.py assignment3.py
7-Zip 9.20 Copyright (c) 1999-2010 Igor Pavlov 2010-11-18 p7zip Version 9.20 (locale=en_US.UTF-8,Utf16=on,HugeFiles=on,2 CPUs)
Scanning
Updating archive OSED-OS-XXXXX-Exam-Report.7z
Everything is Ok
Submission Upload
Please submit your .7z file via https://upload.offsec.com within 24 hours of completion of the exam and follow the provided instructions in order to upload your archived exam report.
The maximum allowable size for uploading your archive file is 200MB. If the size constraints are not met, you would not be able to upload your archive. If you are unable to meet the size constraints, we suggest looking at ways to reduce your file size using techniques such as image compression.
After the file has been uploaded, you will be presented with a "Submit File" button where a MD5 hash of your exam report will be displayed. Make sure to click the "Submit File" button after verifying your MD5 hash to submit your files successfully.
If you do not upload your exam-report via https://upload.offsec.com , it will not be graded.
IMPORTANT NOTE: Please note that some Windows 11 users have encountered an issue while trying to upload their exam files to https://upload.offsec.com , and received file is not a proper format error. This issue may be related to compatibility concerns with Windows 11, and we'd like to provide a solution to ensure a smooth upload process.
To resolve this problem, we recommend using a Kali Virtual Machine (VM) to upload your exam files securely and without any compatibility issues.
For more information about Kali VM, please visit: https://help.offsec.com/hc/en-us/articles/360049796792-Kali-Linux-Virtual-Machine
Acknowledgement of Receipt
Once the report is uploaded successfully, a confirmation email will be sent immediately acknowledging the receipt. If you have not received the email, please ensure that you uploaded your report and clicked the Submit File button on the final page of https://upload.offsec.com after verifying your MD5 hash. We also recommend you to check your email spam and junk folders in case the confirmation email has been flagged as spam.
Additional Required Information
In the unlikely event that we require additional clarification on your exam report, we will get in contact with you via email. You must submit the requested information within 24 hours from the time we have requested it.
Results
You will receive an email with your certification exam results (pass/fail) within ten (10) business days after submitting your documentation. Please note that we do not provide the exam score or solutions to the exam targets.